Filter
Top Products
5
ASSEMBLY
0
2644
026
4
5
02643
BAGGER SUPPORT ASSEMBLY
(See Figs. 1A & 1B)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the support as-
sembly on the bolts. Discard the four (4) shoulder bolts
supplied and go on to Step 2 in struc tions.
1
SELF
TAPPING
SHOULDER
BOLTS
FIG. 1C
PULL OUT ON STOP BRACKET TO
REMOVE SUPPORT ASSEMBLY
FIG. 1B
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
1. Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
2. Hang the support assembly on the bolts.
SHOULDER
BOLTS
FIG. 1A
TO REMOVE THE SUPPORT ASSEMBLY (See Fig. 1C)
1. Pull outward on the stop bracket enough to allow support
assembly to be lifted up and away from drawbar.
2
FIG. 2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
as sis tance of another person for mounting cover assembly
to tractor.
1. Position cover assembly on ground behind tractor as
shown.
2. Lift and rotate cover to align cover bracket with support
assembly.
3. Slide cover assembly down onto the support
assembly.
02646
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
SUPPORT
ASSEMBLY
SUPPORT
ASSEMBLY