Filter
Top Products
10
Overcutt ing begins on the top side of the
log wi t h the bott om of the saw against t he
log. When overcuttinguse lightdownward
pressu re.
Overcutting Undercutting
Undercutti ng involves cutting on the un-
derside of t he log with top of saw against
the log. When undercut t i ng use light up-
ward pressure. Hold saw fir m l y and main-
tain control. Th e saw wil l tend to pus h
back tow ar d you.
WARNING: Neverturn sawupside
down to undercut. The saw cannot be
controlled in this position.
Alwa ys make your fi rst cut on the com-
pressions side of t he l og. The compres-
sion side of the log is where the pressure
of the log’s weight is concentrat ed.
First cut on compression side of log
Second cut
First cut on compression side of log
Second cut
BUCKING WITHOUT A SUPPORT
S Overcut through
1/3 of the diameter of
the log.
S Roll the log over and finish with a sec-
ond overcut.
S Watch for logs with a compression
side to prevent the saw frompinching.
See illustration above for cutting logs
with a compression side.
BUCKING USING A LOG OR
SUPPORT STAND
S Remember your first cut is always on
the compression side of the log.
(Refer to the illustration below for your
first and second cut)
S Your first cut should extend
1/3 of the
diameter of the log.
S Finish with your second cut.
1
st
Cu
t
2
nd
Cut
Usingalogforsupport
2
nd
Cut
1
st
Cut
1
st
Cut
2
nd
Cut
Using a support stand
1
st
Cut
2
nd
Cut
LIMBING AND PRUNING
WARNING: Be alert for and guard
againstkickback. Do notallowthe mov-
ing chain to contact any other branches
or objects at the nose of the guide bar
when limbing or pruning. Allowing such
contact can result in serious injury.
WARNING: Never climb into a tree
to limb or prune. Do not stand on lad-
ders, platforms, a log, or in any position
which can cause you to lose y our b al-
ance or control of the saw.
IMPORTANT POINTS
S Watch out for spring poles. Spring
poles are small size limbs which can
whip toward you or pull you off bal-
ance. Use extreme caution when cut-
ting small size limbs.
S Be alert for spring back from any
branches that are bent or under pres-
sure. Avoidbeings truckbythebranch
or the saw when the tension in the
wood fibers is released.
S Frequently clear b ranches out of the
way to avoid tripping over them.