Filter
Top Products
13
startthesawandcarefullyreenterthecut. To
avoid kickback and chain damage, do not
use ametal wedge. Do notattempt to restart
your saw when itis pinched or hung in a log.
Use a wedge to r emove pinched saw
Turn s aw O FF and use a plastic o r
wooden wedge to force cut open.
Overcutting begins on the top side of the log
with the bottom of the saw against the log.
When overcutting use light downward pres-
sure.
Overcutting
Undercutting
Undercuttinginvolves cutting on theunder-
side ofthe logwithtop ofsawagainstthe log.
When undercutting use light upward pres-
sure. Hold saw firmly and maintain control.
The saw w ill tend to push back t oward you.
WARNING: Never turn saw upside
down to undercut. The saw cannot be con-
trolled in this position.
Always make your first cut on the compres-
sion side ofthe log. Thecompressionsideof
the log is where the pressure of the log ’s
weight is concentrated.
Second cut
First cut on co mpression side o f log
First cut on compression side of log
Second cut
BUCKING WITHOUT A SUPPORT
S Overcut through 1/3 of the diameter of the
log.
S Roll the log over and finish with a second
overcut.
S Watch f or logs w ith a compression side to
prevent the saw from pinching. See il-
lustrations for cutting logs with acompres-
sion side.
BUCKING USING A LOG OR
SUPPORT STAND
S Remember your first cut is always on the
compression side of the log .
(Refer to the illustrations below for your
first and second cut)
S Your first cut should extend
1/3 of the
diameter of the log.
S Finish w ith your second cut.
1
st
Cut
2
nd
Cut
Usingalogforsupport
2
nd
Cut
1
st
Cut
1
st
Cut
2
nd
Cut
Using a support stand
1
st
Cut
2
nd
Cut
LIMBING AND PRUNING
WARNING: Be alert for and guard
against kickback. Do not allow the moving
chain to contact any other branches or objects
at the nose of the guide bar when limbing or
pruning. Allowing such contact can result in
serious injury.
WARNING: Never climb intoa tree to
limb or prune. Do not stand on ladders, plat-
forms,a log, or in a ny position which cancause
you t o lose your balance o r con trol of t he saw .
IMPORTANT POINTS
S Work slowly, keeping both hands firmly
gripped on the saw . Maintain secure f ooting
and balance.
S Watch out for springpoles. Springpoles are
small size limbs which can catch the saw
chain and whiptoward you or pullyou offbal-
ance. Use extreme caution when cutting
small size limbs or slender material.
S Be alert for springback. Watch out for
branches that ar e bent or under pressure.
Avoid being struck by the branch or the
saw when the tension in the wood fibers is
released.
S Keep a clear work area. Frequently clear
branches out of the way to avoid tripping
over them.