Filter
Top Products
-- 5 --
ASSEMBLY
WARNING: Stop engine and be sure
the impeller blades have stopped turning be -
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING: If you receive your unit
assembled, check each step to insure your
unit is properly assembled and all fasteners
are secure. Follow all safety information in
the manual and on the unit.
D A standard screwdriver is required for as-
sembly.
BLOWER TUBE ASSEMBLY
1. Align the rib onthe upper blower tube with
the groove in the blower outlet; slide the
tube into place.
NOTE: Knob must be loose enough to allow
blower tubeto beinserted inblower outlet. Loos-
en knob by turning counterclockwise.
Blower Outlet
Rib
Groove
2. Secure thetubeby turningthe knob clock-
wise.
3. Align the slots on the lower blower tube
with the tabs on the upper blower tube.
Upper Blower Tube
Tab
Slot
Lower Blower Tube
4. Slide the lower blower t ubeonto theupper
blower tube.
5. Turn thelower blower tube clockwise until
a click is felt to secure the lower blower
tube to the upper blower tube.
NOTE: When the upper and lower blower
tubes are assembled together properly , the
arrows on both tubes will be aligned.
6. To remove the tubes, turn the knob coun-
terclockwise to loosen the tubes; remove
the tubes.
HIGH --SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
high--speed nozzle.
1. Align the slots on the nozzle with the tabs
on the lower blower tube.
High--
Speed
Nozzle
Tab
Slot
Lower Blower
Tube
2. Slide the nozzle onto the lower blower tube.
3. Turn the nozzle clockwise until a click is
felt to se cure the noz zle t o the low er blow-
er tube.
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Small Opening
Zipper
Opening
Elbow
Tube
Rib
NOTE: Make sure edge of the small opening
is flush against the f lared area ofthe elbow t ube,
and the rib on the elbow tube is on the bottom.
3. Closethezipper onthe bag.Make surethe
zipper is closed completely.
4. Remove blower tubes from engine.
Rib
Groove
5. Insert theelbowtube intothe blow eroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turnknobclockwisetosecure elbowtube.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. T he rotating blades can cause
serious injury.