Filter
Top Products
13
Cutters
Depth Gauge
Drive Links
8. Placechainoversprocket,fittingthedrive
links in the sprocket.
9. Fitbottom ofdrivelinks between theteethin
the sprocket in the nose of the guide bar .
10. Fit chain drive links into bar groove.
11. Pull guide bar forward until chain is snug
inguidebar groove. Ensureall drivelinks
are in the bar groove.
12. Now, install bar clamp making sure the
adjusting pin is positioned in the lower
hole in the guide bar.
Adjusting Pin
Lower Hole
Guide Bar
13. Install bar clamp nut and finger tighten
only. Do not tighten any further at this
point. Proceed to the CHAIN ADJUST-
MENT section.
CHAIN ADJUSTMENT
See CHECK CHAIN TENSION in MAINTE-
NANCE section.
USER REPLACEABLE SERVICE PARTS
Use only recommended user replaceable service parts as listed below:
Bar 530044908
Chain 952051549
Hex Nut 530015917
Oil Cap 530053072
Bar Adjusting Screw/Pin Kit 530069611
REPLACEMENT PART PART NUMBER
STORAGE
WARNING: Perform the following
steps after each use:
S Allow attachment to cool before storing or
transporting.
S Store attachment with all guards in place.
Position attachment so that any sharp ob -
ject cannot accidentally cause injury.
S Store the attachment in a dry, well venti-
lated area out of the reach of children.
SEASONAL STORAGE
Prepareattachmentforstorageatendofsea-
sonorifitwillnotbeusedfor30daysormore.
Ifyour pruner attachment isto bestored fora
period of time:
S Clean the e ntire attachment.
S Lightly oil external metal surfaces and
guide bar.
S Oil the chain and wrap it in heavy paper or
cloth.
S Check entire attachment for loose screws
or nuts. Replace any damaged, worn or
broken parts.
S At the beginning of the next season, use
onlyfreshfuelhavingthepropergasolineto
oil ratio.