Filter
Top Products
17
12. Now, install bar clamp making sure the
adjusting pin is positioned in the lower
hole in the guide bar.
Adjusting Pin
Lower
Hole
Guide Bar
13. Install bar clamp nut and finger tighten
only. Do not tighten any further at this
point. Proceed to the CHAIN ADJUST-
MENT section.
CHAIN ADJUSTMENT
See CHECK CHAIN TENSION in MAINTE-
NANCE section.
REPLACING THE LINE
(for line tr immer attachment)
1. Removespool byfirmlypullingontapbut-
ton.
2. Clean entire surface of hu b and spool.
3. Replace with a pre-wound spool, or cut two
lengths of
12-1/2 feet of 0.080″ (2 mm) di-
ameter Poulan brand l ine.
WARNING: Never use wire, r ope,
string,etc.,whichcanbreakoffandbecomea
dangerous missile.
4. Insert ends of the lines about 1/2 inch (1
cm) into the small holes on the inside of
spool.
Small
Holes
Spool
H
u
b
Line in Notch
L
i
n
e
i
n
N
o
t
c
h
L
ine e
x
it holes
5. Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrows
found on the spool.
6. Push the lines into the notches, leaving 3
to 5 inches (7 -- 12 cm) unwound.
7. Insertthelinesintothetheexitholesinthe
hub as shown in the illustration.
8. Align the notches with the line exit holes.
9. Push spool into hubuntil it snaps into place.
10. Pull thelines extending outsideofthehub
to release t he lines from the not ches.
Assist handle 530057546
Bolt carriage, 1/4-20 530015786
Wing nut 530016152
Bar 530044908
Chain 952051549
Hex nut 530015917
Oil cap 530053072
Bar adjusting screw/pin kit 530069110
Spool with 0.080″ trimmer line 952711616
Shield assembly 530071964--01
REPLACEMENT PART PART NUMBER
USER REPLACEABLE SERVICE P
A
RTS
STORAGE
WARNING: Perform the following
steps after each use.
S Stop the unit and disconnect the power
source when not in use.
S Carry the unit with motor stopped.
S Allow m otor to cool before storing o r trans-
porting.
S Store unit and extension cord indoors in a
high, dry place out of thereach o f children.
Store unit unplugged.
S Store u nit with a ll guards in place andposition
unit so that any sharp object cannot acciden-
tally cause injury.
SEASONAL STORAGE
Prepare your unit for storage at the end of the
season or if it will not be used for 30 days or
more.
If your unit is to be stored for a period of t ime:
S Clean it thoroughly before lengthy storage.
S Store in a clean dry area.
S Lightly oil external metal surfaces and guide
bar .
S Oil the chain and wrap it in heavy paper or
cloth.