Filter
Top Products
-- 9 --
2. Slowly press the primer bulb 6 times.
3. Move the start lever to the START position.
Start
Lever
Starter
Handle
Primer
Bulb
4. Pull starter rope handle sharply until en-
gine starts and runs.
5. Allow unitto runfor 10--15 seconds, then ful-
ly squeeze the throttle trigger to disengage
the starting system.
STARTING A WARM ENGINE
1. Squeeze and h old the throttle trigger.
2. Pull starter rope sharply while squeezing
throttle trigger until engine runs.
NOTE: Normally , the warm starting proce-
dure can be used within 5--10 minutes after
the unit is turned off. If the unit sits for more
than 10 minutes without being used, it will be
necessary to start the unit by following the
steps under STARTING ACOLD ENGINE o r
following thestartinginstruction steps shown
on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by moving
the start lever to the RUN position and fully
squeezing the throttle trigger. Pull the starter
handle repeatedly while squeezing t hrottle
triggeruntilenginestarts an druns.Thiscould
require pullingthestarter handlemany times,
depending on how badly the unit is flooded.
Iftheunitstilldoesn’tstart,refertotheTROU-
BLESHOOTING TABLE or call
1-800-554-6723.
MAINTENANCE
WARNING: Avoid touching muffler
unless engine and muffler are cold. A hot
muffler can cause serious burns.
WARNING: Stop engine andbe sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury . Always disconnect the spark
plug before performing m aintenance or ac-
cessing movable parts.
HELPFUL TIP
IMPORTANT: Have all
repairs other than the rec-
ommended maintenance
described in theinstruction
manual performed by an
authorized service dealer.
If any dealer other than an authorized
service dealer performs work o n the
product, Poulan PRO may not pay for
repairs under warranty. It is your re-
sponsibility to maintain and perform
general maintenance.
GENERAL RECOMMENDATIONS
Thewarrantyonthisunitdoesnotcoveritems
that have been subjected to operator abuse
or negligence. To receive full value from the
warranty, the operator must maintain unit as
instructed in this manual. V arious adjust-
ments will need to be made periodically to
properly maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
S Muffler
S Spark Plug Boot
S Air Filter
S Housing Screws
CHECK F OR DAMAGED OR WORN
PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
S FuelTank -- Do notuse unit iffuel tank shows
signs of damage or leaks.
S Vacuum Bag -- Do not use vacuum bag if it
is torn or damaged.
INSPECT A ND CLEAN UNIT AND
DECALS
S After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
decals using a damp cloth with a mild deter-
gent.
S Wipe off unit with a clean dry cloth.
CLEAN A IR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean or replace
air filter after every 5 hours of operation or
yearly , whichever comes first.