Filter
Top Products
10
START L EVER
The STAR T LEVER h elps to supply fue l to the
engine to aid in starting. Activate the starting
syst em by moving th e star t lever to the STA RT
position. DO NOT squeeze the throttle trigger
until the engine has started and runs. After the
engine starts, allow the engine to warm--up
10--15 seconds, then fully squeeze the throttle
trigger to deactivate the starting system.
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
BEFORE STARTING ENGINE
WARNING: Be sure to read the f uel
information in the safety rules before you be-
gin. If you do not understand the safety rules,
do not attempt to fuel your unit. Call
1-800-554-6723.
FUELING ENGINE
WARNING: Remove fuel cap slowly
when refueling.
HELPFUL TIP
Toobtain thecorrect oil mix
ratio, pour 3.2 ounces of
2--cycle synthetic oil into
one gallon of fresh gas.
This engine is certified to operate on un-
leaded gasoline. Be for e operation, gas oline
must be mixed with a good quality synthetic
2-cycle air-cooled engine oil designed to be
mixed at a rati o of 40 :1. Poulan/ WEED EA TER
brand synthetic oil is recommended. Mix gaso-
line andoilat a ratio of 40:1.A 40:1ratio is ob -
tainedby mixing3.2ounces (95ml) ofo il with1
gallon(4 liters )of unleaded gas oline. D ONOT
USE automotive oil or marine oil. These oils
will cause engine damage. When mixing f uel,
follow instructions printed oncontainer. Once
oil is added to gasoline, shake container mo -
mentarily to assure that the fuel is thoroughly
mixed. Always read and follow the safety
rules relating to fuel before fueling your unit.
CAUTION : Ne ver use st raigh t gasoline in
your unit. This will cause permanent engine
damage and void the limited warranty.
FUEL REQUIREMENTS
This engine requires the use of minimum 87
octane [R+M]/2 clean gasoline.
IMPORTANT
Use of alcohol blended fuels (called gasohol or
using ethanol or methanol) can cause major en-
gine performance and durability p roblems.
WARNING: Alternative fuels (not gas-
oline) such as E--15 (15% alcohol), E--20 (20%
alcohol), E--85 (85% alcohol)are NOT classified
as gasoline and are NOT approved for use in
2--stroke gasoline engines. Use of alternative
fuels will cause problems such as: improper
clutch engagements, overheating, vapor lock,
power loss, lubrication deficiency, deterioration
of fuel lines, gaskets and internal carburetor
components, etc. Alternative fuels cause high
moisture absorption into the fuel/oil mixture
leading to oil and fuel separation.
HOW TO STOP YOU R UNIT
S Release the throttle trigger.
S Push and release the engine ON/STOP
swit ch. T h e swit ch wi l l aut omat ically ret u rn to
the ON position. W ait 5 seconds before at-
tempti ngto resta rt u nitto all ow s witch toreset.
ON/STOP
Switch
HOW TO START YOUR UNIT
WARNING: Avoid any contact with
the muffler. A hot muffler can cause serious
burns.
Starting position
HELPFUL TIP
If your engine still does not
start after following these
instructions, please call
1--800--554--6723.
STARTINGACOLDENGINE
NOTE:
DO NOT squeeze the throttle trigger
until the engine ha s started and runs.
1. Set unit on a flat surface.
2. Slowly press the primer bulb 6 times.
3. Move the start lever to the ST ART position.
Primer Bulb
Start Lever
Starter Handle