Filter
Top Products
9
Guide Bar
Adjusting
Wheel
Cylinder Cover
Throttle
Lockout
Rear
Handle
Throttle
Trigger
Chain
Direction
of Travel
Chain
Catcher
Clutch
Cover
Bar
Knob
Chain
Brake
ON/ST OP SWI TCH
The ON/ST OP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LO CK--OUT
The THROTTLE LOCK--OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the t rigger.
CHOKE/ FAST IDLE L EV ER
The choke and fast idle are set by pulling the
CHOKE/F AST IDLE LEVER out to the full ex-
tent for cold starting or after refueling. The
choke provides additional fuel to the engine
during cold starting.
PRIMER BULB
The PRIMER BULB circulates fuel to the car-
buretor to provide quicker starting.
CHAIN BRA KE
The chain brake is a device designed to stop
the chain if ki ck ba c k occurs . The chai n brake
activates automatically in the event of kick-
back. The chain b rakeactivates m anually if the
front hand guard is pushed forward. The chain
brake is disengaged by pulling the front hand
guard back toward the front handle as far as
possible.
CHAIN TENSI ON
It isnormalfora new chain to stretchduring the
first 15 minutes of operation. You should check
your chain tension frequently. See CHAIN
TENSION und er the ASSEM BLY section.
WARNING: If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious injury to
the operator a nd/or damage the chain mak-
ing it unusable.
BEFORE STARTING ENGINE
WARNING: Muffler is very hot dur-
ingand after u se. Donot touch the muffleror
allow combustible material such as dry
grass or fuel to do so.
WARNING: Besure toread the f uel
handling information in the safety rules sec-
tionof thismanualbeforeyou begin.Ifyoudo
not understand the fuel handling information
do not attempt to fuel your unit. Seek help
from someone that does understand the in-
formation or call the customer assistance
help line at 1-800-554-6723.
FUELING ENGINE
WARNING: Remove fuelcap slow-
ly when refueling.
HELPFUL TIP
To obtain thecorrect oil mix
ratio, pour 3.2 ounces of
2-- cycle synthetic oil into
one gallon of fresh gas.
This engine is certified to operate on un-
leaded gasoline. Before operation, gasoline
must be mixed with a good quality synthetic
2-cycle air-cooled engine oil designed to be
mix ed a t a ratio of 40: 1. Poul an/WEE D
EATER br a nd syn th et ic o il i s r ecom-
mended. A 40:1 ratio is obtained by mixing
3.2 fluid ounces (95 ml ) of oil wit h 1 gallon (4
liters)of unleadedgasoline. In c luded with this
saw is a 3.2 ounce (95 ml) container of Poulan/
WEED EA TER brand synthetic oil. Pour the
entire contents of this container into 1 gallon (4
liters) of gasoline to achieve the proper fuel
mixtu re . DO NOT USE automotive ormarine
oil. These oils will cause engine damage.
When mixing fuel follow the instructions
printed on the container . Always read and
follow the safety rules listed under HANDLE
FUEL WITH CAUTION.
CAUTION : Never use straight gasoline in
your unit. This will cause permanent engine
damage and void the limited warranty.
FUEL REQUIREMENTS
This engine requires the use of minimum 87
octane [R+M]/2 clean gasoline.
IMPORTANT
Use of alcohol blended fuels (called gasohol or
using ethanol or methanol) can cause major
engine performance and durability problems.