Filter
Top Products
-- 6 --
5. Place the hooks of theupper vacuum t u be
on the retaining posts of the unit.
6. Pivot the tube until it is secured to the
blower unit by the vacuum inlet latch.
Retaining
Post
Hook
Inlet Cover
Latch
PIVOT
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the vacuum tubes by inserting
the tip of a screwdriver int o the latch area
of the vacuum inlet.
2. Gently tilt handle of screwdriver t oward
the back of the unit to release the latch
while pulling upon theupper vacuum t u be
with your other hand.
Latch Area
3. Remove the vacuum bag.
4. Close the vacuum in let cover and make
sure it is latched closed.
5. Reinstall the blower tube (see BLOWER
TUBE ASSEMBLY).
SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown with t he muf fler side
facing away from your body and clothes.
2. Pass the shoulder strap over your head
and onto your right shoulder.
3. Extend your left a rm tow ard the rear ofthe
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
5. Make sure air flows freely from the elbow
tube intobag. If bag is kinked, the unit will
not operate properly.