Filter
Top Products
12
CUTTING A FALLEN TREE
(BUCKING)
Bucking is the term used for cutting a fallen
tree to the desired log size.
WARNING: Do not stand on the log
being cut. Any portion can roll causing loss
of f ooting and control. Do not stand downhill
of the log being cut.
IMPORTANT POINTS
S Cut only one log at a time.
S Cut shattered wood very carefully; sharp
pieces ofwood could beflungtowardoper-
ator.
S Use a sawhorse to cut small logs. Never
allow another person to hold the log while
cutting and never hold thelog with your leg
or foot.
S Do not cut in an area where logs, limbs,
and roots are tangled such as in a blown
down area. Drag the logs intoa clear area
before cutting by pulling out exposed and
cleared logs first.
TYPES OF CUTTING USED F OR
BUCKING
WARNING: If saw becomes
pinched or hung in a log, don’t try to force it
out. Youcan losecontrol ofthe sawresulting
in injury and/or damage to the saw. Stop the
saw,drive awedge ofplastic orwood intothe
cut until the saw canbe removed easily. Re-
startthe sawandcarefully reenter thecut. To
avoid kickback and chain damage, do not
use a metalwedge. Do not a ttempt to restart
your saw when it is pinched or hung in a log.
Useawedgetoremovepinchedsaw
Turn saw
OFF and use a plastic or
wooden wedge to force cut open.
Overcutting begins onthetop sideof thelog
with the bottom o f the saw against the log.
When overcutting use light downward pres-
sure.
Overcutting Undercutting
Undercuttinginvolves cutting on theunder-
side of thelog with top ofsaw against thelog.
When undercutting use light upward pres-
sure. Hold saw firmly and maintain control.
The saw will tend to push back toward you.
WARNING: Never turn saw upside
down to undercut. The saw cannot be con-
trolled in this position.
Always make your first cut on the compres-
sion side of thelog. The compression sideof
the log is where the pressure of the log’s
weight is concentrated.
Second cut
First cut on compression side of log
First cut on compression side of log
Second cut
BUCKING WITHOUT A
SUPPORT
S Overcut t hrough 1/3 of the diameter of the
log.
S Roll the log over and finish with a second
overcut.
S Watch for logs with a compression side to
prevent the saw from pinching. See il-
lustration for cutting logs with a compres-
sion side.
BUCKING USING A LOG OR
SUPPORT STAND
S Remember your first cut is always o n t he
compression side of the log.
(Refer t o theillustration below for your first
and second cut)
S Your first cut should extend
1/3 of the
diameter of the log.
S Finish with your second cut.
1
st
Cut
2
nd
Cut
Usingalogforsupport
2
nd
Cut
1
st
Cut