Filter
Top Products
7
USER REPLACEABLE SERVICE PARTS
Spool with 0.065
!
Trimmer Line 952701666
Assist Handle 530038584
Bolt Carriage, 1/ 4-20 530015820
Wing Nut 530016118
Shield Assembly 530069752
REPLACEMENT PART
PART NUMBER
STORAGE
WARNING:
Perform the following
steps after each use.
S
Stop the unit and disconnect the power
source when not in use.
S
Carry the unit with motor stopped.
S
Store the unit so the line limiter blade can-
not cause injury.
S
Store uni t and ex tension cord indoors in a
high, dry place out of the reach of children.
Store uni t unplugged.
S
Store uni t with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
TROUBLE CAUSE REMEDY
Trimmer head
stops under a
load or does not
turn when switch
is pressed.
1. Allow tip of line to do the cutting.
2. Contact your authorized service dealer.
3. Check Breaker Box.
4. Remove debris.
Line does not
advance or
breaks while
cutting.
1. Check line routing.
2. Rewind l ine tightly and evenly.
3. Use only 0.065 inch (1.65 mm) dia. line.
4. Remove cover and pull 4 inches
(10 cm) of line out of head.
5. Clean uni t.
Line welds onto
spool.
1. Use only 0.065 inch (1.65 mm) dia. line.
2. Replace with correct spool.
3. Cut with tip of line f ully extended.
Line releases
continuously.
1. Check line routing.
2. Replace spool.
Line pulls back
into head.
1. To o little line outside
of head.
2. Line size incorrect.
1. Remove cover and pull 4 inches
(10 cm) of line outside of head.
2. Use only 0.065 inch (1.65 mm) dia. line.
TROUBLESHOOTING TABLE
1. Line i mproperly
routed in head.
2. Spool damaged.
1. Line size is incorrect.
2. Incorrect spool.
3. Line i s being crowded
against material being
cut.
1. Line i mproperly routed
in head.
2. Line i mproperly
wound into spool.
3. Incorrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Crowding trimmer line
against material being
cut.
2. Electrical failure.
3. Thrown c ircuit breaker.
4. Debris stopping head.
Line usage i s
excessive.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line f ully extended.
4. Replace spool.
1. Line i mproperly routed
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged.
WARNING:
Alwaysstopunit anddisconnect fromthe pow ersour cebeforeperforming
all of the recom mended r emedies below except remedies that require unit to be oper ating.