Filter
Top Products
6
S
Pinching the saw chain along the
top of the guide bar may pus h the
guide bar rapidly back toward the
operator.
S
Either of these reactions m ay cause
you to lose c ontrol of the saw which
could result in serious injury.Do not
rely exclusively upon the safety de-
vices built i nto your saw .
The following guide bar and chain combina-
tions meet kickback requirements of CSA
Z62.1, Z62.3, & ANSI B175.1 when used on
saws listed in this manual. Use of bar and
chain combinations other than those listed is
not recommended and may not meet the
CKA requirements per standard.
Computed kickback angle (
CKA)
Table
BAR
P/N Length CHAIN P/N
18”
MODEL
295
21
_
CKA without
chain brake
952044578 952051313
CKA with
chain brake
12
_
NOTE:
This saw complies with Federal
OSHA regulations for commercial logging.
SAFETY NOTICE:
Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vessel or
nerve damage in the fingers, hands, and
joints of people prone to circulation disorders
or abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or
texture, or loss of feeling in the fingers,
hands, o r joints, discontinue the use of this
tool and seek medical attention. An
anti-vibration system does not guarantee the
avoidance of these problems. Users who
operate power tools on a continual and
regular basis must monitor closely their
physical condition and the condition of this
tool.
SPECIAL NOTICE:
Your saw is equipped
with a temperature limiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All
U.S.
forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require
many internal combustion engines to be
equipped with a spark arrestor screen by
law. If you operate a chain saw in a state or
locale where such regulations exist, you are
legally responsible for maintaining the
operating c ondition of these parts. Failure to
do so is a violation of the law. Refer to the
CARE AND MAINTENANCE section for
maintenance of the Spark Arrestor.
Failure to follow all Safety Rules and Precau-
tions can result in serious injury. If situations
occur which are not covered in this manual,
use care and good judgement. If you need
assistance, c ontact your Authorized Service
Dealer or call 1-800-554-6723.
ASSEMBLY
The assembly tool provided with your saw
is the only tool needed for assembly. Pro-
tective gloves (not prov ided) should be
worn during assembly.
ATTACHING THE BAR & CHAIN
WARNING:
Recheck each assem-
bly step if the saw is received assembled. Al-
ways wear gloves when handling the chain.
The chain is sharp and can cut you even
when it is not moving!
S
Loosen and remove the clamp nuts and
the chain brake from the saw.
S
Remove the plastic shipping spacer (if
present).
Chain Brake
Clamp Nuts
Assembly Tool
Location of shipping spacer
S
An adjusting pin and screw isused to ad-
just the tension of the chain. It is very im-
portant when assembling the bar, that
the pin located on the adjusting screw
aligns into a hole in the bar. Turning the
screw will move the adjustment pin up
and down the screw. Locate this adjust-
ment before you begin mounting the bar
onto the saw.