Filter
Top Products
4
thetic oil isrecommended. (A 40:1 ratio is ob-
tained bymixing 3.2ouncesof oilwith1gallon
of unleaded gasoline). When mixing fuel fol-
low the instructions printed on the container.
Always read andfollow the safety rules under
FUEL SAFETY.
STARTING
HOW TO STOP YOUR UNIT
To stop engine, move ON/OFF switch to the
OFF position.
HOW TO START YOUR UNIT
Starting Position
Choke lever
Primer Bulb
Trigger
Muffler
WARNING:
The trimmer head will
turn while starting the engine. A hot muffler
can cause serious burns.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
S
Set uni t on a flat surface.
S
Move ON/OFF switch to the ON position.
S
Slowly press the primer bulb 6 times.
S
Move c hoke lever to FULL CHOKE posi-
tion.
S
Squeeze the throttle trigger fully and hold
through
all remaining steps
.
S
Pull starter r ope handle sharply 6 times.
S
Move choke lever t o HALF CHOKE posi-
tion.
S
Pull starter rope handle no more than 6
pulls, until engine runs.
S
Allow engine to run 10 seconds, then move
choke lever to OFF CHOKE position.
STARTING A WARM ENGINE
S
Move ON/OFF switch to the ON position.
S
Move choke lever toOFF CHOKE position.
S
Pull starter r ope handle until engine runs.
S
If engine does not start in 5 pulls, follow
instr u c tio nsinSTAR TINGA COL DENGINE.
USING YOUR UNIT
It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.
OPERATING POSITION
Eye
Protection
Long Pants
Heavy Shoes
ALWAYS WEAR:
Cut from your right to your left.
ADVANCING THE CUTTING LINE
Advance line bytapping the bottom of the cut-
ting head lightly on the ground while engine is
running at full speed. A metal blade attached
to the shield will cut the line to the proper
length.
TWIST--N-- EDGE
S
Pull the tab toward the engine.
S
Twist the tube to the edging position;
release the tab.
Tab
REPLACING THE LINE
S
Remove spool by firmly pulling on tap but-
ton.
S
Clean entire surface of hub and spool.
S
Replace with a pre-wound spool, or cut a
length of 20 feet of 0.080” (2 mm) diameter
Poulan/Weed Eater
r
brand line. Never use
wire, rope, string, etc., which can break off
and become a dangerous missile.
S
Insert one end of the line about 1/2 inch (1
cm) into the small hole on the inside of
spool.
Small
Hole
Spool
Hub
Line exit hole
Line in Notch
S
Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrow
found on the spool.
S
Push the line into the notch, leaving 3 to 5
inches (7 -- 12 cm) unwound.