Filter
Top Products
18
MAINTENANCE
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff to prevent
engine dam age from overheating. Clean with a wire brush
or compressed air to re move dirt and stubborn dried gum
fi bers.
ENGINE COOLING FINS
SPARK
PLUG
AIR SCREEN
SCREWS
BLOWER HOUSING
SCREWS
DIPSTICK TUBE
AS SEM BLY
ENGINE COOLING FINS (See Fig. 15)
Remove any dust, dirt or oil from engine cooling fi ns to
prevent engine damage from overheating.
• Remove screws from blower housing and lift housing
and dipstick tube assembly off engine.
• Cover oil fi ll opening to prevent entry of dirt.
• Use compressed air or stiff bristle brush to thoroughly
clean engine cooling fi ns.
• To reassemble, reverse above procedure.
OIL FILL
OPENING
FIG. 15
FIG. 16
ENGINE OIL FILTER
Replace the engine oil fi lter every season or every other
oil change if the tractor is used more than 100 hours in
one year.
AIR FILTER (See Fig. 16)
Your engine will not run properly using a dirty air fi lter.
Replace pre-cleaner after every 25 hours of operation or
every season. Service paper cartridge every 100 hours of
operation or every season, whichever occurs fi rst.
Service air cleaner more often under dusty conditions.
• Pull up on air fi lter cover handle and rotate towards
engine.
• Remove cover.
• Carefully remove air fi lter cartridge and pre-cleaner
from base.
• Clean base carefully to prevent debris from falling into
carburetor.
NOTE: If very dirty or damaged, replace cartridge.
• Place new pre-cleaner and cartridge fi rmly in base.
• Align tabs on cover with slots in blower housing and
replace cover.
• Hook handle on cover and push down on handle to
close.
IMPORTANT: Petroleum solvents, such as kerosene, are
not to be used to clean the cartridge. They may cause
de te ri o ra tion of the cartridge. Do not oil cartridge. Do not
use pres sur ized air to clean cartridge.
SLOTS
TABS
BASE
CARTRIDGE
PRE-CLEANER
COVER
HAN DLE
MUFFLER
Inspect and replace corroded muffl er and spark arrester
(if equipped) as it could create a fi re hazard and/or dam-
age.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of operation, whichever
occurs fi rst. Spark plug type and gap setting are shown in
“PROD UCT SPECIFICATIONS” section of this manual.