Adjusting Screw - 1/4Turn
• Lift up the tip of the bar and tighten the
chain brake nuts with the bar tool.
• Recheck chain tension.
KNOW YOUR CHAIN SAW
Chain Brake
_Nuts .
_,WARNING: if the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious injury.
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW Compare the illustrations with your unit to familiarize yourself with the location of
the various contrefs and adjustments. Save this manual for future reference.
Chain Front Hand Guard "_- Front Handle
Adjustment Tool
(Bar Tool) Starter Rope
ON/STOP
Switch
Chain Muffler
Primer
M
Bar Oit Fill Cap Housing Fuel Mix Fill Cap
Cylinder Cover
Throttle _
Lockout o
Rear \ _ttiet
Handle _
Throttle Choke/
Trigger Fast idle Chain Chain Nuts
Lever Brake Catcher
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine
THRO'FrLE TRIGGER
Time THROlqLE TRIGGER controls engine
speed.
THRO'FrLE LOCK-OUT
Time THRO]q-LE LOCK-OUT must be
pressed before you can squeeze the throttle
thgger. This feature prevents you from acci-
dentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle are set by pulIing the
CHOKE/FAST IDLE LEVER out to the falI ex-
_ Chain
s%1 Sw,,ng fr#a°
'_ Chain Brake '
Bar Sprocket Hefe
tent for cold staring or after refueling. The
choke provides additional fuef to the engine
during cefd staring.
PRIMER BULB
The PRIMER BULB circulates fuel to tile car-
burefor to prowde quicker starting.
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs. The chain
brake activates automatically in the event of
kickback. The chain brake activates manually
if the front hand guard is pushed forward. The
chain brake is disengaged by pulling the front
hand guard back toward the front handle as far
as possible.