Poulan 183187 Lawn Mower Accessory User Manual


 
7
B
B
B
B
02558
B
02445
DEFLECTOR SHIELD
HINGE BRACKET
REAR LATCH
REAR GAUGE
WHEEL
BRACKET
DEFLECTOR
SHIELD
FRONT
LATCH
REAR LATCH
WITHOUT
GAUGE WHEELS
WITH REAR
GAUGE WHEELS
EXTENDED EDGE "B"
Must be under defl ector shield
and along side the hinge bracket
FIG. 5
ALIGN CHUTE "B"
WITH MOWER "B"
OPTIONAL
GAUGE
WHEEL
AND
BRACKET
PUSH IN
5
CAUTION: Do not remove discharge
guard from mower. Raise and hold guard
when attaching lower chute and allow it
to rest on chute while in operation.
LOWER CHUTE (See Fig. 5)
1. Lower mower deck to its lowest cutting position.
NOTE: If equipped, remove mulch cover from mower deck
and store in a safe place.
2. With your right hand, raise and hold defl ector shield in
upright position.
3. With your left hand, hold lower chute as shown and
position lower rear edge of chute between gauge wheel
bracket tab and mower housing, then carefully release
defl ector shield and hook rear latch to mower deck.
4. Raise defl ector shield and align "B" on lower chute
extended edge with "B" on mower housing.
5. With your right hand, push fi rmly on the lower chute
until the extended edge slides under the defl ector shield
and along side the hinge bracket as shown.
6. With chute in proper position, hold the chute securely,
so it does not move, while hooking the front latch to
the mower deck.
NOTE: While hooking the latches, the defl ector shield may
try to push the chute away from the mower deck opening.
It is important to hold the chute in position while hooking
the latches to the mower deck.
• If your tractor is equipped with gauge wheels on the
deck, then it will be necessary to hook the rear latch
into the hole in the R.H. gauge wheel bracket.
PLACE LOWER REAR EDGE
BETWEEN GAUGE WHEEL
BRACKET TAB AND
MOWER HOUSING, THEN
HOOK REAR LATCH