Filter
Top Products
25
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the Repair
Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The fuse
holder is located behind the dash.
SERVICE AND ADJUSTMENTS
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 34)
• While holding spring bushing with wrench, loosen jam
nut.
• Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments.
• Turn adjustment bolt counterclockwise for lighter at-
tachments.
• Retighten jam nut against spring bushing.
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER. ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION.
ADJUSTMENT
BOLT
JAM NUT
ATTACHMENT
LIFT SPRING
SPRING BUSHING
FIG. 34
HEADLIGHT
WIRE
CONNECTOR
FIG. 35
HOOD
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 35)
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
• To replace, reverse above procedures.