Poulan 173304 Lawn Mower User Manual


 
7
ASSEMBLY
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
KNOB
FLAT WASHER
SEAT
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
Remove adjustment knob and flat washer securing seat
to cardboard packing and set aside for assembly of seat
to tractor.
Pivot seat upward and remove from the cardboard
packing. Remove cardboard packing and discard.
Place seat on seat pan and assemble shoulder bolt.
Tighten shoulder bolt securely.
Assemble adjustment knob and flat washer loosely. Do
not tighten.
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
Get off seat without moving its adjusted position.
Raise seat and tighten adjustment knob securely.
FIG. 3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Operation
section, page 10, for location and function of
controls)
Press lift lever plunger and raise attachment lift lever to
its highest position.
Release parking brake by depressing clutch/brake pedal.
Place freewheel control in freewheeling position to
disengage transmission (See “TO TRANSPORT” in the
Operation section of this manual).
Roll tractor forward off skid.
Remove banding holding discharge guard up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Opera-
tion section, page 10, for location and func-
tion of controls)
WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
Be sure all the above assembly steps have been
completed.
Check engine oil level and fill fuel tank with gasoline.
Place freewheel control in "transmission engaged" po-
sition.
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
Place motion control lever in neutral (N) position.
Press lift lever plunger and raise attachment lift lever to
its highest position.
Start the engine. After engine has started, move throttle
control to idle position.
Release parking brake.
Slowly move the motion control lever forward and slowly
drive tractor off skid.
Apply brake to stop tractor, set parking brake and place
motion control lever in neutral position.
Turn ignition key to "OFF" position.
Continue with the instructions that follow.
FIG. 2
BATTERY
BOX DOOR
SEAT PAN
LABEL
TERMINAL
TERMINAL
TO SET UP YOUR MOWER FOR MULCHING
Remove high performance blades and install mulcher
blades, (see BLADE REMOVAL in the CUSTOMER
RESPONSABILITY section of this manual).
YOUR MOWER CAME FACTORY EQUIPPED WITH HIGH
PERFORMANCE BLADES, WHICH ARE THE BEST
BLADES FOR BAGGING AND DISCHARGING. TO USE
YOUR MOWER WITH THE HIGH PERFORMANCE BLADES
THE MULCHER PLATE MUST BE REMOVED FROM THE
MOWER (SEE FIG. 4).
IMPORTANT: FOR SHIPPING PURPOSES, THE
MULCHER PLATE WAS PREATTACHED TO YOUR
MOWER. THE MULCHER PLATE MUST ONLY BE USED
WITH THE MULCHING BLADES THAT CAME PACKED
SEPARATELY IN THE CARTON.