Filter
Top Products
ASSEMBLY
7
HOW TO SET UP YOUR TRACTOR
CONNECT BATTERY (See Figs. 2 and 3)
CAUTION: Do not short battery ter-
mi nals by allowing a wrench or any
other object to contact both terminals
at the same time. Before connect-
ing battery, re move metal bracelets,
wristwatch bands, rings, etc.
Positive terminal must be connected
fi rst to prevent sparking from ac ci den tal
grounding.
• Remove cardboard packing from seat pan and lift seat pan to raised po-
si tion.
• Open battery box door.
• Remove terminal protective caps and discard.
• If this battery is put into service after month and year indicated on label (label
located between terminals) charge battery for minimum of one hour at 6-10
amps.
• First connect RED battery cable to pos i tive (+) terminal with hex bolt, fl at
wash er, lock washer and hex nut as shown. Tighten securely.
• Connect BLACK grounding cable to neg a tive (-) ter mi nal with remaining hex
bolt, fl at wash er, lock washer and hex nut. Tighten securely.
• Close battery box door.
Open battery box door for:
• Inspection for secure connections (to tighten hard ware).
• Inspection for corrosion.
• Testing battery.
• Jumping (if required).
• Periodic charging .
POSITIVE
(RED) CABLE
NEGATIVE
(BLACK) CABLE
HEX
BOLT
FLAT
WASHER
HEX
NUT
LOCK
WASHER
DISCARD TERMINAL
PRO TEC TIVE CAPS
FIG. 2
SEAT
PAN
BATTERY
BOX DOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
• Remove cardboard packing on seat pan.
• Place seat on seat pan and assemble shoul der bolt.
• Assemble adjustment bolt, lock washer and fl at washer loosely. Do not
tighten.
• Tighten shoulder bolt securely.
• Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached which allows you to press
clutch/brake pedal all the way down.
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment bolt securely.
FIG. 4
ADJUSTMENT
BOLT
FLAT WASHER
LOCK WASHER
SHOULDER
BOLT
SEAT
SEAT PAN