Poulan 33 Trimmer User Manual


 
5
position and pull the rope until engine runs,
but no more than 6 pulls.
Choke
position
decal
Arrow on
choke
lever
STARTING A WARM ENGINE
S
Move the choke lever to the HALF CHOKE
position.
S
Squeeze and hold the throttle trigger. Keep
throttle trigger fully squeezed until the en-
gine runs smoothly.
S
Pull starter rope sharply until engine runs,
but no more than 5 pulls.
S
Allow engine to r un 15 seconds, t hen move
the choke lever to the O FF CHOKE position.
NOTE:
If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the choke lever in the OFF CHOKE position;
then, pul l the rope to clear the engine of ex-
cess fuel. This could require pulling the starter
handle many times depending on how badly
the unit is flooded.
If the unit still doesn’t start, refer to
TROUBLESHOOTING TABLE or call
1-800-554--6723.
USING YOUR UNIT
OPERATING POSITION
Eye
Protection
Long Pants
Heavy Shoes
ALWAYS WEAR:
Cut from your left to your right.
REPLACING THE LINE
Choose the line size best suited for the job at
hand. Green--colored line is designed for cut-
ting grass, red--colored line for grass and
small weeds. T he black--colored line is de-
signed for cutting larger weeds and light
brush.
S
Before inserting the line into the holes in the
cutting head, identify the proper holes.
When using green or red, insert line into the
holes marked small on the cutting head.
Black line should be inserted in the holes
marked large.
S
Insert both ends of your line through the
proper holes in the side of the cutting head.
Small
holes
Positioning
Tunnel
Large
holes
S
Insert ends of the line one at a time through
the positioning tunnels.
Line against
the hub
S
Pull the line and make sure the line is
against the hub and extended fully through
the positioning tunnels.
S
Correc tly installed line will be the same
length on both ends.
SERVICE
We recommend all service and adjustments
not listed in this manual be performed by an
authorized service dealer.
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter caps.
Carburetor adjustments is a complicated
task. We recommend that you take your unit
to an authorized service dealer. Damage will
occur if you turn the needles beyond the limit-
er stops.
IGNITION TIMING
The ignition timing is fixed, non--adjustable.
SPARK PLUG
Replace the spark plug yearly using a Cham-
pion RCJ--8Y plug. Spark plug gap is 0.025”.
NEED ASSISTANCE?
Need Assistance?
Call 1--800--554--6723
Need Service Part?
Contact your dealer.