Filter
Top Products
13- ENG
D26183
How To Change Pump Oil
1. Loosen oil fill cap.
2. Place a container under the oil drain
plug.
3. Remove oil drain plug.
4. After oil is drained replace oil drain plug.
Tighten securely.
5. Remove oil fill cap and fill with
recommended oil. See the Pump Oil
Chart for the correct amount and type
of oil.
6. Replace oil fill cap and tighten securely.
MAINTENANCE
WHEN PERFORMING MAINTENANCE, YOU MAY BE
EXPOSED TO HOT SURFACES, WATER PRESSURE, MOVING
PARTS, OR FIRE RESULTING IN DEATH. BEFORE PERFORMING ANY MAIN-
TENANCE OR REPAIR, DISCONNECT SPARK PLUG WIRE, LET ENGINE
COOL AND RELEASE ALL WATER PRESSURE. THE ENGINE CONTAINS
FLAMMABLE FUEL. DO NOT SMOKE OR WORK NEAR OPEN FLAMES
WHILE PERFORMING MAINTENANCE.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.
PUMP
NOTE: The pump was filled with oil at the factory.
1. Change pump oil after the first ten (10) hours of operation and every fifty (50)
hours thereafter.
30 W non detergent
PUMP TYPE
OIL TYPE
OIL CAPACITY
PUMP OIL CHART
ENGINE
Refer to engine manual for the manufacturer’s recommendations for any and all
maintenance.
Oil Fill Plug
Oil
Drain
Plug
Sight Glass
Nameplate
Annovi Reverberi (XMV)
13.5 oz.