Filter
Top Products
16 — ENG
D22885
5. Add RV antifreeze to hose as shown.
6. Pull engine starter rope slowly several times until
antifreeze comes out of high pressure hose con-
nection of pump.
7. Remove short hose from water inlet of pump.
8. Install spark plug into spark plug hole and tighten
securely, then reconnect spark plug wire.
9. Drain all water from high pressure hose, coil it, and
store it in cradle of the pressure washer handle.
10. Drain all water from spray gun and wand by hold-
ing spray gun in a vertical position with nozzle end
pointing down and squeezing trigger. Store in
gun/hose holder.
11. Store chemical hose, high pressure hose, spray
gun, and wand so they are protected from dam-
age, such as being run over.
It is recommended that you follow these steps to pro-
tect the internal seals of the pressure washer when
storing the unit for an extended period and WHEN
FREEZING TEMPERATURES ARE EXPECTED.
ENGINE
1. Consult the Engine Owners Manual for the manu-
facturer's recommendations for storage.
PUMP
NOTE: If storing the unit for more than 30 days RV
antifreeze needs to be run through the pump. This
helps prevent damage within the pump head. RV
antifreeze is not only added for winterizing, but for
proper lubrication regardless of temperature or en-
vironment. Storing the pump less than 30 days does
not require the RV antifreeze.
1. Obtain a funnel, six ounces of RV antifreeze, and
approximately 12 inches of garden hose with a
male hose connector attached to one end.
Use only RV antifreeze.
Any other antifreeze is
corrosive and can damage pump.
2. Disconnect spark plug wire.
3. Disconnect high pressure hose from pump and
from spray gun.
4. Connect 12 inch length of hose to water inlet of
pump.
STORAGE