Filter
Top Products
9- ENG
A01296
UNPACKING
1. Locate the parts carton and set aside
for later use.
2. Cut wire ties holding generator to
pallet and remove protective
wrapping.
3. Remove all packaging, leaving
generator on pallet.
IMPORTANT: DO NOT remove generator
from pallet.
4. Discard all packaging.
Wire Tie
Protective
Wrapping
ASSEMBLE WHEEL KIT
Tools needed:
2 - 2x4 at least 30” long
1 - 1/2" socket
1 - 1/2" open end wrench
1 - hammer
1 - pliers
Kit Contains:
2 - Handles
2 - Wheels
1 - Axle
2 - Foot Brackets
Parts bag contains:
2 - Handle Grips
6 - Screws, 5/16-18X2.00
1 - Cotter Pin
1 - Flat Steel Washer
2 - Axle Spacers
6 - Cap Screw 5/16-18 X .75
8 - Flange Nuts
2 - Wheel Brackets
1 - 5/8" Axle Cap
2 - Rubber Bumpers
2 - Kep Nuts, 1/4-20
2 - Handle Brackets
2 - Snap Buttons
1. Lift the gas tank end of generator and slide 2x4
between generator and pallet as shown.
The generator is too heavy to be
lifted by one person. Obtain as-
sistance from others before lifting.
NOTE: Photos are shown for clarity only, DO
NOT tilt generator onto it's end.
2. Attach rubber bumpers (10) to foot brackets (1) using
screws (9) and keps nuts. Tighten securely.
3. Attach foot bracket assembly (1) to generator frame
with screws (9). Tighten screws securely. NOTE:
These screws are self-tapping and may require
pressure to start. Repeat on other side.
2x4
Gas Tank
9
10
1
9