Porter-Cable D26221-025-1 Pressure Washer User Manual


 
13- ENG
D26221
How To Change Pump Oil
1. Loosen oil fill cap.
2. Place a container under the oil drain
plug.
3. Remove oil drain plug.
4. After oil is drained replace oil drain
plug. Tighten securely.
5. Remove oil fill cap and fill with 30W
non detergent oil. Pump capacity is
18.54 oz.
6. Replace oil fill cap and tighten
securely.
MAINTENANCE
WHEN PERFORMING MAINTENANCE, YOU MAY BE
EXPOSED TO HOT SURFACES, WATER PRESSURE,
MOVING PARTS, OR FIRE RESULTING IN SERIOUS INJURY OR DEATH.
BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, DISCONNECT
SPARK PLUG WIRE, LET ENGINE COOL AND RELEASE ALL WATER
PRESSURE. THE ENGINE CONTAINS FLAMMABLE FUEL. DO NOT SMOKE
OR WORK NEAR OPEN FLAMES WHILE PERFORMING MAINTENANCE.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.
PUMP
NOTE: The pump was filled with oil at the factory.
1. Change pump oil after the first ten (10) hours of operation and every fifty (50)
hours thereafter.
ENGINE
Refer to engine manual for the manufacturer’s recommendations for any and all
maintenance.
Oil Fill Cap
Oil
Drain
Plug
Sight Glass