Filter
Top Products
2- ENG
D26052
BEFORE ASSEMBLY
1. Shut off the pressure washer and turn
off the water supply.
2. Pull trigger on gun handle to relieve
any water pressure.
3. Disconnect the high pressure hose
from the gun.
TO ASSEMBLE HOSE REEL
1. Attach handle to flange assembly.
NOTE: Screws must be inserted from
the inside of hose reel and secured
with nuts on the outside as shown.
Tighten securely.
2. Remove quick connect plug from high
pressure hose.
3. Apply sealant tape to hose reel inlet
hose and assemble quick connect to
hose reel inlet hose.
4. Bolt hose reel to reel bracket as
shown. Tighten securely. NOTE: If unit
is not equipped with hose reel bracket
order hose reel bracket (part number
D23163).
5. Apply sealant tape to swivel end of
high pressure hose. IMPORTANT: The
high pressure hose has a swivel end
and fixed end. The swivel end must
be used to attach high pressure hose
to hose reel, see below to determine
fixed and swivel ends. If quick
connect socket is assembled on
swivel end, remove and connect it to
fixed end of hose.
6. Feed high pressure hose through slot
(1) in flange assembly and connect to
swivel (2). Tighten securely.
7. Make a loop in hose as shown. Place
hose into hose clamp (3), squeeze
hose clamp together, slide onto long
screw post, and secure with nut (4).
Tighten securely. NOTE: Do not
overbend or kink hose.
1
2
4
3
hose end with swivel
hose end without swivel