Filter
Top Products
10- ENG
D29525
TYPICAL INSTALLATION OF BATTERY
• Recommended Battery for Electric Start: 12V - 45 A H. or 210 CCA (Cold
Cranking Amps)
• Purchase battery and battery hardware separately, not included with unit.
1. Place battery in rack with terminals facing to-
wards generator head.
2. Place battery bracket (A) over battery as
shown in Figure (opposite battery terminals).
3. Place "L" bolt (B) through top and bottom
brackets and secure with wing nut (C).
4. Locate the solenoid on the left side
of the unit.
5. Remove the nut from the solenoid
post and place one end of the posi-
tive (red) battery cable onto the
post. Reassemble nut and tighten
securely.
Lawn & Garden batteries can
come in two terminal
configurations. The Positive (+) and Negative (-)
terminals can be oriented so that they are +/-
or -/+. See Figure. In the unlikely event that the
battery terminals are unmarked, we
recommend that you return the battery to the
retailer for exchange for a properly marked
battery or let an authorized service center install the battery for you. Failure
to connect the battery properly can possibly cause bodily injury. In addition,
extensive engine electrical damage not covered under warranty can result.
6. Attach the other end of the positive
(red) battery cable to the positive (+)
terminal on the battery.
To Prevent sparks
connect the red
(positive) cable to the positive (+)
terminal before connecting the black
negative cable.
7. Attach one end of the negative
(black) cable to the negative (-)
terminal on the battery.
8. Attach the other end of the negative
(black) cable to the frame as shown.
Install the star washer between the
cable and the frame.
(-) Negative Battery Cable Connection
Star Washer
Negative (-)
Battery Cable
IMPORTANT: See caution before
connecting cable to battery.
Negative (-)
Battery Cable
Positive (+)
Battery Cable
Solenoid
Nuts