Filter
Top Products
11- ENG
A02871
9. On other handle depress snap button (9), slide into handle bracket, and
release through first slot in handle bracket as shown. Secure handle to
handle bracket with screw (7) and flange nut (8).
10. Attach handle bracket assemblies to frame with screws (7) and flange nuts
(8). Tighten securely.
NOTE: Orientation of handle assemblies to frame will depend on how the
operator wishes to operate snap button (9). If snap button is assembled
to outside of the generator frame the fingers will operate it. If snap button
is assembled to inside of the generator frame the thumbs will operate it.
The figure shows the snap button assembled to inside of generator frame
11. Remove shipping block from under the gen head. Unscrew bolt and remove
the shipping block. It is very important that this is removed before starting
your generator.
12. Carefully tilt the generator to operating position.
13. The portability kit is now ready for use.
14. To lower handle, depress snap button and fold handles down.
15. Raise handles and allow snap button to snap into place.
Risk of moving parts. Keep fingers away from
all moving parts. Contact with moving parts
can result in serious injury. Keep children away from the
generator at all times. They may not be able to recognize the
hazards of this product.
7
9
7
9
9
8
OTHER LOOSE PARTS
1. Oil is supplied, see engine operators manual for correct procedure to add
oil and fuel to engine.
2. The locking plugs may be used when needed or required.
The locking plugs are to be installed and/or used in
accordance with appropriate local electrical code
regulations. Refer to instructions enclosed with each plug for proper
installation.
IMPORTANT: Before any attempt to start your generator be sure to check
engine oil (See Engine Operator's manual)