Filter
Top Products
www.polarispool.com
4
Assemble Cleaner
1. Remove the pressure tester from the hose by
unscrewing the hose nut and pulling off hose.
2.
Use hose nut from the pressure tester to secure
hose to the cleaner body at the feed pipe.
3. The filter bag is packaged in the collar area on the
cleaner body. Pull out the bag and snap the bag tie
collar onto the feed hose.
4. Push Head Float all the way in, against cleaner body.
5. Place the Polaris into the pool. Turn on the pool
filtration pump.
Check for Proper Wheel RPM
Before operating the Polaris, check for proper wheel revolutions per minute (RPM). For
maximum efficiency, the Polaris should operate between 28 and 32 RPM.
1. Mark the single-wheel side tire.
2. Turn pump on, hold cleaner below water level and count wheel revolutions for 1 minute.
3. Optimum speed should be
between 28 and 32 RPM.
If count is less than 28 RPM:
• Check the filter screen in the Quick Disconnect for debris.
•
Clean the skimmer, filter and pump basket.
• Check the hoses, connections and swivels for leaks.
• If the cleaner is connected to a dedicated return line, adjust the 3-way diverter to
increase water flow.
If count is more than 32 RPM, unscre
w the Pressure Relief Valve until the proper RPM is
reached.
If an adjustab
le v
alv
e has been installed, adjust the v
alve to reduce the amount of
water flow.
Single-wheel Side
Sweep Hose
Hose Nut
Feed
Pipe
English