Filter
Top Products
Included in this box:
• “PUSH TO EXIT” and “PRESIONE PARA SALIR”
message plates.
• Six color-coded, 12-inch, AWG 18 wire leads with easy-
to-attach spade lugs for fast installation.
• Stainless-steel slimline plate.
• 680 ohm resistor for 24-volt LED operation.
Wiring for SD-7103GC-PTQ (with timer module)
1. Connect the RED wire to the spade connector “+” and the BLACK wire to the spade connector “-“ (see Fig. 1).
2. Connect 12~24 volts AC or DC power (non-polarity) to the power input terminal block of timer module (see Fig. 3).
3. Connect an NO or NC device to the relay output terminal block as required.
4. Connect the positive and negative wire of the buzzer to the buzzer output terminal block if necessary.
5. Set the ideal time of the timer module between 1~180s via the VR rotary knob as shown. Turn clockwise to increase
and counterclockwise to decrease. Test to ensure the timer is set correctly.
Fig. 3
Fig. 1Fig. 1
Fig. 2
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a period of one (1) year from the date of
sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to
SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty
installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at SECO-LARM’s option. In no event shall SECO-LARM
be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is one of continual development
and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints or
typographical errors.
Copyright © 2009 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of
SECO-LARM.
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326 E-mail: sales@seco-larm.com
MiSD-7103GC-PxQ_0912.docx
Order part # 763-148-2%
A
l
so
fr
o
m
S
E
CO
-LARM:
“Handicap”
Push-to-Exit Button with
Stainless-Steel Plate
Green Mushroom Push-
to-Exit Plate
Push-To-Exit Button
with Switchable English
& Spanish Message
Plates
Slimline Push-to-Exit
Plate
SD-7202BC-HCQ SD-7201GCPE1Q SD-7202GC-PEQ SD-7101KBPE1Q