Filter
Top Products
3
Installation
The Deck Jet body is designed to be connected to a 3/4” Sch40 PVC pipe (Figure 2). After the pipe is
pressure tested, solvent weld the Deck Jet body to the 3/4” supply pipe. NOTE: Use PVC/ABS glue only.
Anchor the Deck Jet body, with the Deck Jet cover attached, so the cover is level with the finished deck
surface.
Once the deck is finished, flush any debris from the supply pipe using the pump and filter system that
supplies the Deck Jet. Apply Teflon
®
tape to the threads of the swivel base. Remove any debris from the
cup and screw the swivel base into the Deck Jet body (Figure 2).
By hand, push the swivel nozzle until it snaps onto the swivel base (Figure 3).
Operation
Start the pump and adjust the appropriate valves as necessary to create the desired water effect.
If the stream of water is disrupted, remove the Deck Jet Cover, Jet and Jet Swivel Base. Check to see if
there is any debris blocking the Jet.
To winterize, remove the Jet and Jet Swivel Base. Blow the lines clear with air, and install a 1/2” threaded
plug.
¾” Sch40 pipe slip
connection
Figure 2
¾” supply pipe
Figure 3
Solvent weld ¾” supply
pipe to ¾” Sch40 pipe
slip connection
Swivel base
Attach Teflon tape to the swivel
base and screw the swivel
base into the Deck Jet body
By hand, push the swivel
nozzle on to the swivel base
until it snaps into place
Swivel nozzle
Swivel base