Filter
Top Products
P/N 350039 Rev. C 8-24-06 2
OptiFlo
®
Engineered Plastic Pump Installation, Operation & Service Manual
Table of Contents
SECTION I. HOW YOUR PUMP WORKS ............................................................................................... 3
SECTION II. INSTALLATION ................................................................................................................. 3-6
SECTION III. PUMP OPERATION AND MAINTENANCE ....................................................................... 6
SECTION IV. SEAL REPLACEMENT PROCEDURE ............................................................................ 6-7
SECTION V. WINTERIZING PROCEDURE .............................................................................................. 7
SECTION VI. TROUBLESHOOTING GUIDE ............................................................................................. 8
SECTION VII. TECHNICAL DATA ........................................................................................................ 9-12
WARNING
To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.
WARNING
Before installing this product, read and follow all warning notices and instructions accompanying this pump. Failure to follow safety warnings and instructions
can result in severe injury, death, or property damage. Call (800) 831-7133 for additional free copies of these instructions.
Important Notice
Attention Installer.
This manual contains important information about the installation, operation and safe use of this product. This information should be
given to the owner/operator of this equipment.
PUMP SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
WARNING
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
This pool pump must be installed by a licensed or certified electrician or a qualified pool serviceman in accordance with the National Electrical
Code and all applicable local codes and ordinances. Improper installation will create an electrical hazard which could result in death or
serious injury to pool users, installers, or others due to electrical shock, and may also cause damage to property.
Always disconnect power to the pool pump at the circuit breaker before servicing the pump. Failure to do so could result in death or serious
injury to serviceman, pool users or others due to electric shock.
WARNING
Risk of Electrical Shock. Connect only to a grounding type receptacle protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician
if you cannot verify that the receptacle is protected by a GFCI.
WARNING
Do not bury the electrical cord. Locate the cord to minimize the abuse from lawn mowers, hedge trimmers, and other equipment.
WARNING
To reduce the risk of electrical shock, replace damaged cord immediately.