Filter
Top Products
2 C274M-E (12/05)
Important Safety Instructions
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should be done only by qualified service personnel and conform to all local codes.
2. Installation shall be done in accordance with all local and national electrical and mechanical codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maximum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
Description
The PA402 is a pole mount adapter designed for use with the Spectra
®
, Legacy
®
, DF5, and DF8 Series wall mounts. The PA402 will mount to any
pole with a 3-inch (7.62 cm) to 8-inch (20.32 cm) diameter. Stainless steel mounting straps are supplied to secure the adapter to the pole.
The PA402 pole mount adapter is designed for the following wall mounts:
IWM Series Wall mounts with cable feedthrough for use with Spectra, DF5, or DF8 Series pendant style domes.
IDM4018 Wall mount with removable end cap and cable feedthrough for use with Spectra, DF5, or DF8 Series pendant style domes.
LWM41 Legacy wall mount. For use with Legacy integrated positioning systems.
Installation
To attach the PA402 pole mount adapter to a pole, perform the following steps:
1. Determine the placement of the PA402 on the pole by measuring the height of the CCTV equipment to be mounted.
2. Position the PA402 on the pole and secure with the stainless steel mounting straps (provided).
3. Attach the wall mount to the studs on the PA402 and secure with the nuts and split lock washers (provided).
4. Attach the equipment to the wall mount according to the instructions provided with the mount.
NOTE:
Included with the PA402 is a block-off plate with conduit knockouts. It is recommended that the block-off plate be used in outdoor
applications. The block-off plate is not needed when using the IWM24 mount.