Filter
Top Products
3/31/2004
151-071M
Great Plains Mfg., Inc.
5
Installation Instructions
3P600 Drive
See
Figure 6
3P600 Drive Assembly
18728
Figure 6:
1. Mount bearing and flanges (1) inside end
panels of drill frame. Use 5/16 x 1 inch bolts
(2), washers and nuts to secure flanges.
Leave bolts loose.
2. Install drive shaft (3) through bearings. As you
install shaft, place 22 tooth sprocket (4) on
shaft to the left of gearbox.
3. Place 17 tooth sprocket (5) on shaft near the
left drill frame end panel.
4. Place 12 tooth splined sprocket (6) on left
front gearbox shaft. Secure with snap ring (7).
5. Align shaft and tighten flange bolts. Align
sprockets (4 and 5). Secure with keys (8 and
9).
3P600 Drive w/Small Seeds Option
If your drill is equipped with a small seeds option,
a majority of the agitator drive is already installed.
Refer to Figure 6:
• Place 17 tooth sprocket (5) near left drill
frame end panel.
• Align sprocket and secure with key (9).
• Go to step 7b on page 6.