Filter
Top Products
3. Install the suspension bracket and the flange of fan
body to joists by using long screws (ST4.2X20).
(If spacing A between joists is 10 1/4 12 inches,
~
install the flange of fan body according to Fig.3-2,
others according to Fig.3-1 install the product.)
4. Install the suspension bracket to joists by using long
screws (ST4.2X20) and secure it to the fan body by
using screw (ST4.2X12). (Fig.4)
5. Remove junction box cover and secure conduit or
stress relief to junction box knock-out hole. (Fig.5)
6. Refer to wiring diagram (page 4).
Using wire nuts, connect house power wires to
ventilating fan wires and lighting unit wires:
black to black; white to white; green to green;
Replace the junction box cover. (Fig.5)
CAUTION:
Mount junction box cover carefully so that lead
wires are not pinched.
7. Squeeze the circular duct to fit the adaptor,
then slipped onto the adaptor and secure
it with duct tape.
h
4 inc es
Squeeze
Fig. 4
Fig. 3-2
2 Long screws
(ST4.2X20)
Screw
(ST4.2X12)
Joist
Fig. 3-1
INSTALLATION (JOIST MOUNTING- ) CONTINUED
Fan body
2 Long screws
(ST4.2X20)
Joist
A=10 1/4 12 inches
~
4 Long screws (ST4.2X20)
Fan body
Joist
6
Fig. 5
Knock-out hole
Junction box
cover
Joist
Duct tape
Circular duct
Conduit
Wire nut
Green wires
Lead wires
Junction box
Conduit