Filter
Top Products
EN
7
TO MANUALLY SET CLOCK
1. Press and hold MODE.
2. Press
/ to change setting options. The settings
order is: country, city, display contrast, +/-1 time zone,
12/24 hour format, hour, minute, year, month-day / day-
month, month, day and language.
3. Press MODE to conrm.
NOTE The language options are English (E), German (D),
French (F), Italian (I) and Spanish (S).
NOTE If the clock signal is valid, you are unable to
manually set the time.
ALARM
TO SET ALARM
1. Press ALARM to enter Alarm mode.
indicates in Alarm mode.
2. Press and hold ALARM to enter settings.
3. Press
/ to set hour and minute.
4. Press ALARM to conrm.
5. Press MODE to return to clock display.
TO ACTIVATE / DEACTIVATE ALARM
1. Press ALARM to enter Alarm mode.
indicates in Alarm mode.
2. Press ALARM repeatedly to activate or deactivate
alarm.
indicates alarm is On.
3. Press MODE to conrm and return to clock display.
TO SILENCE ALARM
• Touch SNOOZE / LIGHT to snooze alarm for 8 minutes
OR
• Press any key to turn the alarm off and activate it again
after 24 hours.
DISPLAY CONTRAST
You can adjust the clarity level of the display. Press and hold
MODE until “CONTR” is shown, then select from 0 (lowest)
to 15 (highest) by pressing
/ for your preferred level
of display contrast. Press MODE to conrm.
BACKLIGHT
Touch SNOOZE / LIGHT to activate backlight for 8 seconds
(only when connected to stand).
RESET
Press RESET to return to the default settings.
MOUNTING / PLACING OF UNIT
To mount onto a wall:
Use the hole located at the back of the unit.
TIP Leave a small gap between the wall and the unit to
prevent unit from heating up. Insufcient ventilation may
distort indoor temperature / humidity readings.
To place on horizontal surface, such as desk:
Align unit with the stand. Place unit downwards and tilt
slightly backwards to allow unit to lean on the stand.