Filter
Top Products
24
TROUBLESHOOTING
OREGON® CORDLESS TOOL SYSTEM
HEDGE TRIMMER MODEL HT255
AD 0213 F/N 558936
SYMPTOM POSSIBLE CAUSE RECOMMENDED ACTIONS
Low cut time per
battery charge
Cutting blades are dull Have the cutting blades professionally sharpened.
Worn cutting blades
Have the cutting blades replaced at an approved
service location.
Bent cutting blades
Have the cutting blades replaced at an approved
service location.
Improper cutting
technique
Follow guidelines in “Basic cutting”.
Higher cutting speed
than necessary
Apply less pressure to the throttle trigger.
Resin buildup
preventing cutting
blade movement
See “Blade care”.
Battery pack not fully
charged
See “Charging the battery pack”.
Blinking orange
light on charge
state indicator
Charger short circuit,
charger over current,
over voltage limit, open
circuit on battery pack,
or charge/pre-charge
time out error
1. Make sure the charger cord is connected to both
the charger and the electrical outlet.
2. Make sure the charger is receiving the correct
voltage.
3. Try charging another battery pack designed for
this charger.
If this does not correct the problem, have the
function checked at an approved service location.