Filter
Top Products
TOP-PLATE FILE HANDLE DEPTH-GAUGE SETTING: FINISHED
FILING ANGLE: DOWN ANGLE:
*
See warning below CUTTER:
30˚
For more information on these and other Oregon
®
products, contact your authorized Oregon
®
distributor, or:
OREGON CUTTING SYSTEMS DIVISION, BLOUNT, INC. PO Box 22127 · Portland, OR, U.S.A. 97269-2127
Phone: 503-653-8881 Fax: 503-653-4201 Web: http://www.oregonchain.com
IN CANADA: OREGON DISTRIBUTION LTD. 505 Edinburgh Rd. N., Guelph, Ontario, Canada N1H 6L4
Phone: 519-822-6870 Fax: 519-822-4999
Printed in USA 91VG F&B A107041 AA 0806
*
*
Hand Filing Instructions OREGON 91VG
®
TOP-PLATE TOP-PLATE DEPTH-GAUGE SETTING: FINISHED
GRINDING ANGLE: SHARPNESS ANGLE: DOWN ANGLE:
*
See warning below CUTTER:
30˚
FILE SIZE: Use a 5/32” round file and file guide
Grinding Instructions OREGON
®
91VG
NOTE: Individual parts packages contain 25 pieces.
Chain Replacement Parts
Chain Type Left-hand Cutter Right-hand Cutter Tie Strap Preset Tie Strap Drive Link
91VG P21693 P21694 P24295 P25068 P21721
Maintenance Tools
File Size Assembled File
Guide
Round Files Depth Gauge
Tool, .025”
Flat File Bench Grinder
Wheel 5 3/4”
Mini Grinder
Wheel, 4 1/8”
5/32” 37534 (EA.) 70504 (12-PK.)
40458 (2-PK.)
22290 (10-PK.) 12211 (12-PK.) OR534-18 OR4125-18
GRINDING WHEEL THICKNESS: 1/8”
these
Oregon® 91VG saw chain is low-kickback saw chain. It met the
kickback performance requirements of ANSI B175.1 (US) and
CSA Z62.3 (Canada) when tested on a representative sample of chainsaws. Its safety features
significantly reduce the hazard of kickback while maintaining high-cutting performance.
ALL CUTTING SAW CHAIN CAN KICKBACK, which may result in severe injury to the saw
operator or bystanders. Operate your saw safely. Read and follow all warnings
in your chainsaw operator’s manual.
Failure to follow filing instructions can increase
the level of kickback which can result in severe
injury to the saw operator or bystanders.
Do not exceed the depth-gauge setting shown above
Always file depth gauges back to their original rounded or ramp
shape after lowering
.0˚
.0˚
.025”
.025”
50˚