NuTone 9315XT Patio Heater User Manual


  Open as PDF
of 2
 
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
SAFETY INSTRUCTIONS
Carefully read all instructions and product labels before
beginning installation. Only mount the heater in a vertical
position. Mount the heater by setting the unit on the sub-plate
on the wall. Do not mount the heater over a bathtub or in a
shower stall enclosure. When mounted, the heater should
not be closer than 6" to an adjacent wall. Do not block the
wall heater – i.e., by mounting under a towel rack, behind a
door, etc.
Wall Heaters
MODELS: 9315T, 9315XT
FIGURE 1
FIGURE 2
NOTE: The heater is wired (shipped from the factory) for
1500 watts. The wattage may be reduced to 750 watts by
disconnecting the red wire (on 240 volt unit) or the black
wire (on 120 volt unit) as illustrated in Figures 4 and 5.
UNIT DIMENSIONS
Housing: 8
7
⁄8" high x 11
1
⁄2" wide x 3
3
⁄8" deep.
Grille: 9
3
⁄8" high x 12" wide x
5
⁄8" deep.
Wall Cutout: 8
1
⁄
4" L x 11" W.
MOUNTING THE HOUSING
(New Construction)
Refer to Figure 1
1. Choose heater location. Make sure the heater will not be
mounted closer than 6" from a vertical surface.
2. Set the mounting guides (2) for desired wall thickness.
NOTE: Plaster flange must be flush with finished wall.
Place the mounting guides against the wall stud. When
the finished wall is installed, the wall surface will fit
between the mounting guide bracket and the plaster
flange.
3. Using nails or screws, mount the feet of the unit to the
sub-plate stud. The flange must be flush to the finished
plaster line.
4. Run wiring from circuit breaker or fuse box to wall switch
(not provided) then to heater location.
5. Install box connector into wiring entrance hole in housing's
junction box.
6. Pull wiring through entrance hole and secure cable to box
connector. Allow 6" of wiring to make connections.
7. Finished wall opening should be 8
1
⁄4" high x 11" wide.
ELECTRICAL SPECIFICATIONS
ELEMENT TOTAL VOLTS,
MODEL WATTS WATTS 60Hz
9315T 750/1500 800/1550 120
9315XT 750/1500 800/1550 240
MOUNTING GUIDE
THERMOSTAT
MOUNTING BRACKET
SUB PLATE
TYPE WALL
CONSTRUCTION
MOUNTING GUIDE