THERMOSTAT INSTALLATION
Refer to FIGURE 2
NOTE: The thermostat control circuit must be wired prior to the
wiring of the heater unit.
This heater may be thermostatically controlled by either a line
voltage wall-mounted thermostat (Model 86W), or an optional built-
in thermostat accessory kit (Model 90). Model 90 thermostat kits
are designed for easy installation with this heater. Instructions for
installing thermostats are provided below and are also supplied
with each thermostat kit.
OPTIONAL LINE VOLTAGE WALL-MOUNT THERMOSTAT
1. Locate thermostat on an inside wall away from all drafts and
approximately 4-5 feet above the floor.
2. Route all wiring through the thermostat first and then to the
heater.
OPTIONAL (MODEL 90) UNIT-MOUNT THERMOSTAT
Refer to FIGURE 3
1. Remove the top cover from the heater.
2. Remove the 5/8” knockout located on the left side of the front
panel (use a screwdriver to remove the knockout). Also remove
the two plastic hole plugs (see illustration).
3. Install thermostat from back side of front panel and fasten in
place, from front, with two screws and washers provided (see
illustrations).
4. Attach temperature control knob by gently pushing it on to the
thermostat shaft. Flats on shaft and knob must line up for proper
installation (do not force control knob onto shaft).
5. Remove black wire from thermal fuse and attach it to thermo-
stat terminal marked “4”.
6. Remove white wire from temperature limit terminal marked “1”
(Note: the other end of this wire is attached to incoming field
wiring) and attach it to the thermostat terminal marked “1”.
7. Attach black thermostat wire to thermal fuse and white ther-
mostat wire to the temperature limited marked “3”.
INSTALL THE HEATER
Refer to FIGURE 4
1. Mark the intended mounting location in the base plate under
the counter or kickspace, and remove required material to pro-
vide for easy insertion and removal of the heater cabinet.
2. The unit will be secured in place with screws through the side
angle support brackets. Provide adequate material behind side
angle support for secure mounting.
FIGURE 2
FIGURE 3
SIDE
ANGLE SUPPORT
BRACKETS
FIGURE 4