Filter
Top Products
READ & SAVE THESE INSTRUCTIONS!
INSTALLATION INSTRUCTIONS
10" Round Ceiling Fan
MODEL: 8490 SERIES
TYPICAL INSTALLATION IN
EXISTING CONSTRUCTION
IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE. ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
B. Before servicing or cleaning unit, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the
service panel.
CAUTION:
For general ventilating use only. Do not use to exhaust hazardous
or explosive materials and vapors.
INSTALLATION INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A. Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
B. Sufficient air is needed for proper combusition and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
C. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the outdoors.
E. If this unit is to be installed over a tub or shower, it must
be marked as appropriate for the application.
F. NEVER place a switch where it can be reached from a tub
or shower.
•
Do not mount over tub or in shower stall enclosure.
•
Suitable for use with solid-state speed control.
•
CAUTION: To reduce risk of fire and to properly exhaust air,
be certain the unit is ducted to the outside. Do not vent
exhaust air into spaces within walls or ceiling or into attics,
crawl spaces or garages.
• WARNING: Disconnect power before servicing.
INSTALLATION
IN EXISTING CONSTRUCTION
PREPARING THE INSTALLATION SITE
IMPORTANT: 18" minimum clearance space above ceiling
is required.
1. Cut 11" diameter opening in ceiling adjacent to ceiling joist.
Install header so that housing can be supported on two sides.
If opening cannot be located adjacent to joist, install two
headers for proper housing support.
2. Disconnect power at circuit breaker. Run house wiring
(with ground) from wall switch to fan location.
IMPORTANT: Be certain all wiring complies with electrical
codes and the unit is properly grounded.
ROOF CAP
(SOLD SEPARATELY)
ADJUSTABLE
MOUNTING
BRACKET
MODEL 854 FILTER
(SOLD SEPARATELY)
GRILLE
GRILLE SCREW
OUTLET BOX
8" DUCT
(PURCHASE LOCALLY)
MOUNTING THE HOUSING
NOTE: The mounting brackets and hanger bars included with
the unit will not be used for installation in existing construction.
1. Remove grille screw, motor bracket assembly and outlet box from
the unit.
2. Remove tape from louvers and be certain both damper sections
operate freely.
3. Position housing into the cutout. Feed house wiring through
the outlet box opening.
NOTE: The housing must be positioned so that the joist
or header will not interfere with installation of the outlet box.
4. Using screws or nails, secure the housing to the joist/header(s)
through the keyhole slots provided in sides of housing. Be
certain plaster flange is against finished ceiling.
5. Connect 8" ductwork.