Filter
Top Products
9
8.0 Trouble shooting guide EN
To avoid unnecessary disappointments, you should check the following before contacting the
Nilfi sk service organisation:
Symptom Cause Recommended action
Machine refuses to start Machine not plugged in Plug in machine.
Defective socket Try another socket.
Fuse has blown Replace fuse. Switch off other machines.
Defective extension cable Try without the ex ten sion cable.
Machine stops Fuse has blown Replace fuse. Switch off other machines.
Incorrect mains voltage Check that the mains voltage corresponds to
specifi cation on the model tag.
Thermal sensor activated Wait - the machine will start after a few
minutes.
WARNING! The trigger of the spray gun
must not be activated.
Fuse blows Fuse too small Change to an installation higher than the
amp. consumption of the machine.
You may try without the extension cable.
Machine pulsating Air in inlet hose/pump Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply of Check that the water supply corresponds to
mains water specifi cations required (see model tag)
NB! Avoid using long, thin hoses (min 1/2")
Nozzle partially blocked Clean the nozzle (see section 4.1)
Water fi lter blocked Clean the fi lter (see section 4.2)
Hose kinked Straighten out hose.
High pressure hoses too long Disconnect high pressure extension hoses
and retry. (Extension hose max. 7 m).
Machine often starts Pump/spray gun is Contact your nearest Nilfi sk Service Centre.
and stops by itself leaking
Machine starts, but Pump/hoses or accessory Wait for pump/hoses or accessory to thaw.
no water comes out frozen
No water supply Connect inlet water.
Water fi lter blocked Clean the fi lter (see section 4.2)
Nozzle blocked Clean the nozzle (see section 4.1)
Pump pressure drops Button for regulation of Adjust the button to correct working pressure.
pressure / water volume not
correctly adjusted
(not available on model B)
In case problems other than the above occur, please contact your local Nilfi sk distributor.
UK:
Customer Services at Penrith - 01768 868995