Filter
Top Products
SERVICE POINTS
Cab Clean Air & Recirculation
Filters
Proper heating and cooling performance depends on
proper air flow through the cab clean air and
recirculation filters. Recirculation air filters should be
cleaned with mild soap and water as required by
conditions during regular service. Clean cab air
recirculation filters improve air conditioning system
efficiency and make cab comfort easier to maintain.
Note: Be sure cab recirculation filters are not
blocked. A clear flow path must be maintained for
optimum cab comfort.
TG Tractor -
The clean air filter is located below the cab door. The
recirculation filters are located on both sides of the
operator’s seat near the floor mat.
Cab air & recirculation filters – As required
(recommended 1500 hours)
TJ Tractor -
The clean air filter is located underneath the left rear
corner of the cab. The recirculation filter is located
directly behind the operator’s seat.
Cab air & recirculation filters – 1500 hours
Batteries
Current models of New Holland equipment use
maintenance-free batteries. Terminals should be
cleaned as necessary. On
older models without
maintenance-free
batteries, clean terminals
as necessary and check
electrolyte levels before
and after winter storage.
Engine Air Filters
To maintain engine power and performance, clean the
primary filter when notified by tractor instrumentation. Do
not clean the secondary (inner) filter element. The
secondary (inner) filter element should only be replaced.
TG Tractor -
Primary & secondary engine air filters – as required
(recommend 1200 hours or annually)
TJ Tractor -
Primary & secondary
engine air filters –
1500 hours
Fuses & Relays
TG Tractor -
Engine circuit protection fuses are located inside the
engine service door below the engine air filter assembly.
The tractor circuit fuses and relays are located below the
floor mat behind the operator’s seat.
TJ Tractor -
All fuses and relays are located under the removable
panel to the left of the operator’s seat.