Filter
Top Products
NEUTON MA 5.6 Striper Roller -
Safety & Operating Instructions
3
Figure 5
Tool and Supplies Needed:
• Bag of fine sand
• Funnel
• Hammer (optional)
1. Install one (1) of the two (2) End Caps (found in a plastic bag stapled around a Hook Arm) in one end of the Striper
Roller (Figure 3).
The End Cap fits snugly so you may have to gently tap it in with a Hammer.
2. Stand the Roller on the end with the End Cap installed and fill the Roller through the opposite hole in the Roller with
fine sand using a Funnel and then install the second End Cap.
3. Insert the Hooks into the Slots provided at the rear of the Mower (Figure 2 on the previous page).
For ease of inserting the Hooks, hold the Roller Arms up against the Handlebars.
4. After inserting the Hooks, lower the Striper Roller to the ground (Figure 4), attach the Bagger or insert the Mulching
Plug, and simply create the lawn pattern of your choice as you mow!
See Figure 5 for some examples of lawn patterns you can create with your new Striper Roller.
Figure 4
Hooks
in Slots
Figure 3
End Cap installed
TIP
TIP
TIP