Filter
Top Products
6
Panel ConTRols and ConneCTions
sPeCifiCaTions
10. FUSE COMPARTMENT
Replace with only the same type fuse. If the fuse blows continuously, have the unit serviced by
qualied personnel. The PM-200A powered mixer uses 20mm glass tube Fast Blow fuses: 6A
250V for 115VAC, 3A 250V for 230VAC.
11. AC VOLTAGE SELECTOR SWITCH
Before plugging in the power cord, check to see that the unit is set for the proper voltage for
your area: ~115V (60Hz) or ~230V (50Hz).
12. HEAT SINK
The heat sink can get very hot during high power operation. Make sure to leave properly
ventilated and avoid touching.
13. MOUNTING SOCKET
On the bottom panel of the PM-200A
is a 5/8” dia. socket for mounting the
PM-200A on a mic stand. Depending
on your mic stand, you may require
the optional MSA-100/200A Mic Stand
Adapter for most secure mounting. For
ordering, see PM-100/200A Optional
Accessories Ordering Form included.
13
PM-200A bottom and
standard mounting socket
MSA-100/200A Mic
Stand Adapter
Mic Input balanced XLR
Input Impedance 2KΩ
Maximum Input -10.2dBm (235mV)
Sensitivity (for max output
w/Volume max) -40dBm (7.5mV)
Line Input balanced/unbalanced TRS 1⁄4”
Input Impedance 20KΩ
(10KΩ unbalanced)
Maximum Input +22dBm (10V)
Sensitivity (for max output
w/Volume max) -10dBm (230mV)
Line Output balanced XLR
Output Impedance 1.4KΩ
Maximum Output
(w/10K load) 15.5dBm (4.3V)
EQ and Volume rotary knobs
High +/-12dB @ 10K Hz
Mid +/-12dB @ 2.5K Hz
Bass +/-12dB @ 120 Hz
Headphone Output 1⁄4” TRS Stereo
Power 2 x 80mW @ 32Ω
Power Amp Output 2 internal speakers,
2 external 1⁄4” outputs
Power 2 x 50W RMS @ 8Ω
(Total 100W RMS)
2 x 75W RMS @ 4Ω
(Total 150W RMS)
Frequency Response 20Hz – 50KHz
THD 0.055%
S/N -81dB
Noise Floor .200uV
Amplier protection clipping LEDs,
thermal runaway, short circuit,
anti-thump on/off protection
Internal Speakers 5” full-range
Impedance 8 Ω
Voice Coil diameter 1”
Power Requirements Selectable,
115VAC/60Hz or 230VAC/50Hz
Fuse Requirements 5x20mm glass tube F.B.
6A 250V @ 115VAC
3A 250V @ 230VAC
Weight 9.6 lbs. (4.4 Kg)
Dimensions (HWD) 11.1” x 7” x 6.1”
(28 x 18 x 15.5 cm)
Specications subject to change at any time
without prior notice for purposes of product
improvement