Filter
Top Products
PREPARATION
11
F–030406L
UNPACKING INSTRUCTIONS
The mower was fully assembled at the factory.
When the mower was put in the carton, the
handle was put in the storage position. To put
the handle in the operating position, follow the
steps below.
Handle
1. Remove the mower from the carton.
2. Put the lower handle in the operating posi-
tion. Make sure the lower handle is be-
tween the locking tabs (Figure 1).
3. Put the upper handle in the operating
position. Tighten the wingnuts.
CAUTION: Be careful when you fold or
raise the handle. Do not damage the
cables. A cable that is bent will not work
correctly. Before you use the unit, re-
place a bent or damaged cable.
4. To attach the recoil–start grip to the rope
guide, twist the rope through the rope
guide mounted on the right side of the han-
dle (Figure 2).
NOTE: If you cannot attach the
recoil–start grip because the rope is too
short, hold the engine stop lever
against the handle. Slowly pull the
recoil–start grip.
Rear Wheels (Hi–Wheel Models With
Axle Knobs)
1. Remove the washers and axle knobs
from the axle bolts (Figure 3).
2. Mount the rear wheels onto the axle bolts
and fasten with the washers and axle
knobs.
Upper Handle
Locking
Tabs
Lower Handle
Wingnut
Wingnut
Handle
Bracket
Figure 1
Figure 2
Recoil–Start
Grip
Rope
Guide
Figure 3
Rear Wheel
Washer
Axle Knob
Axle Bolt