Filter
Top Products
ASSEMBLY
11
F-040740L
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
(B)
17x47
1. Carefully remove the plastic bag from the seat.
2. Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge with the fasteners
as shown.
3. Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
Figure 1
Seat
Seat
Adjusting Hole
Seat Hinge
A
B
HOW TO ASSEMBLE THE STEERING WHEEL
Fasteners are not required to assemble the steering wheel. Attach
the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Look at the hub of the steering wheel. Make sure the locking
clip is in place inside the hub.
3. Slide the cover over the steering post (Figure 2).
4. Slide the steering wheel onto the steering post. Push on the
steering wheel. The steering wheel will lock onto the steering
post. Pull on the steering wheel. Make sure the steering wheel
is locked in place.
5. Some models have an decal in the parts bag. Attach the decal
to the center of the steering wheel as shown.
Steering Wheel
Steering Post
Cover
Decal (Optional)
Figure 2
Hub
HOW TO ASSEMBLE THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels. The
fasteners are shown at full size.
(A)
31x11
(B)
17x91
1. Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted in the LOW position. To change
the position to a higher cutting position, see “How To Adjust
The Gauge Wheels” in the Maintenance section.
Gauge Wheel
Figure 3
Axle Bolt
A
B