Filter
Top Products
PREPARATION
14
F–030416C
3. Attach the engine stop cable to the en-
gine. Models with Briggs & Stratton en-
gines are shown in Figure 4. Models with
Tecumseh engines are shown in Figure 5.
4. Make sure the engine stop cable moves
freely. If the cable does not move freely, re-
peat the above steps.
CAUTION: A cable that is bent or damaged
will not work correctly. Before you use the
unit, replace a damaged cable.
5. Attach the cable to the handle with the
cable fastener(s) as shown in Figure 3.
CAUTION: If a cable fastener is missing, a
cable can be too near the muffler. Heat from
the muffler can damage the cable. Before
you use the unit, replace a missing cable
fastener.
WARNING: The blade will rotate
when the engine runs.
6. Attach the recoil–start grip and rope to
the right or left side of the handle with the
rope guide. Fasten with a locknut
(Figure 6).
NOTE: If you cannot attach the recoil–start
grip because the rope is too short, hold the
engine stop lever against the handle. Slow-
ly pull the recoil–start grip.
Figure 4
Engine Stop
Cable
Briggs
Engine
Engine Stop
Cable
Engine
Stop Cable
Figure 5
Tecumseh
Engine
Figure 6
Recoil–Start
Grip
Rope Guide
Locknut
15x116