Multiquip GBHM Landscape Lighting User Manual


 
PAGE 24 — GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09)
OPERATION
APPLYING POWER
If using a portable generator, plug the AC power cable 1.
to the 120 VAC receptacle on the generator used. See
Figure 27.
Connecting to GeneratorFigure 27.
Start the generator as indicated in the generator 2.
manual.
If using power source other than a portable generator, 3.
plug the AC power cord to a 120 VAC, receptacle. See
Figure 28.
Connecting to 120 VAC ReceptacleFigure 28.
The balloon will start to infl ate as soon as power is 4.
applied and the lamp will turn on.
SHUTDOWN
Turn off the power switch of the generator.1.
Disconnect the AC power cable from the generator. 2.
The balloon should start to defl ate and the lamp will
20A
120V
120 VAC
RECEPTACLE
POWER
CABLE
TYPICAL
GENERATOR
FRONT PANEL
EXTERNAL
SINGLE-PHASE
(120 VAC)
POWER SOURCE
POWER CABLE
RECEPTACLE
NOTICE
If the power cable is accidentally unplugged from
the power source, wait three to fi ve minutes before
reconnecting the power. This will allow time for the fan
to reset and ensure balloon will infl ate properly when
power is reconnected.
turn off.
SHUTTING DOWN LAMP ONLY
Unzip the bottom of the balloon. See Figure 29.1.
Unzipping BalloonFigure 29.
Push the button above the LED with a blunt object for 2.
three seconds as shown in Figure 20. LED will turn
red and the lamp will turn off. The balloon will remain
deployed.
Turning Off Lamp OnlyFigure 30.
BALLOON
PUSH WITH
BLUNT OBJECT
LED
NOTICE
To turn lamp back on, unplug the power cable from
the power source. Wait three to fi ve minutes before
reconnecting the power. Reconnect the power cable
and the lamp should turn on and the balloon will
infl ate.