Filter
Top Products
DCA-60SSAI — PARTS AND OPERATION MANUAL— FINAL COPY (09/15/01) — PAGE 43
Lubrication Oil
Fill the engine crankcase with lubricating oil through the filler
hole, but do not overfill. Make sure the generator is level.
With the dipstick inserted all the way, but without being screw
into the filler hole, verify that the oil level is maintained
between the two notches (Figure 33) on the dipstick. See
Table 11 for proper selection of engine oil.
Fuel
Fill the fuel tank with clean and fresh
diesel fuel.diesel fuel.
diesel fuel.diesel fuel.
diesel fuel.
DO NOT
fill the tank beyond capacity.
Pay attention to the fuel tank capacity when replenishing
fuel. Refer to the fuel tank capacity listed on page 23,
Specification Table 7.
The fuel tank cap must be closed tightly after filling. Handle
fuel in a safety container. If the container does not have a
spout, use a funnel. Wipe up any spilled fuel immediately.
DCA-60SSAI — PRE-SETUP
Figure 33. Engine Oil Dipstick
When checking the engine oil, be sure to check if the oil is
clean and viscous. If the oil is not clean, drain the oil by
removing the oil drain plug, and refill with the specified amount
of oil as outlined in the Isuzu Engine Owner's Manual.
liOrotoMdednemmoceR.11elbaT
egnaRerutarepmeTliOepyT
F°32~F°401
)C°5-~C°04(
03EAS
F°5~F°32
)C°51-~C°5-(
03-W01EASro02EAS
)°51-(C°5woleB03-W01EASroW01EAS
CAUTION
:
Never fill the fuel tank while the engine is
running or in the dark. Diesel spillage on
a hot engine can cause a fire or
explosion. If diesel spillage occurs, wipe
up the spilled diesel completely to
prevent fire hazards.
Coolant
Use only drinkable tap water. If hard water or water with
many impurities is used, the inside of the engine and radiator
may become coated with deposits and cooling efficiency
will be reduced.
An anticorrosion additive added to the water will help prevent
deposits and corrosion in the cooling system. See the engine
manual for further details.